Latest News: Forums Technical Can’t get pre-bend Re: Re: Can’t get pre-bend

#9233
Algol
Member

@Colin Parkstone wrote:

Algol, What size pin are you using,maybe it does not have much movment if its a large one.

It’s 6mm. I’m going to go through the whole setup process again this week as soon as I borrow a rig tension gauge.

@Colin Parkstone wrote:

If not, i would say you were not set as well as you could have been and may have only over ridden the lack of prebend with mainsheet tention and have been lucky to have had enough wind to have over riden the hard leach tention a hard mainsheet would have given you.

I’d say you were about spot on there, Colin. The conditions were between sitting in, out for a bit, back in almost straight away, slide out a bit etc etc